1. When the fully automatic blow molding machine is being repaired, press the touch screen fault repair button to ensure safe maintenance. If you need to manually observe the action of each individual cavity, please pay attention to the position of the robot. At the same time, be sure to clear the role of separate buttons to ensure that the malfunction caused unnecessary trouble.
2. When the high-low pressure air source switch is turned on, it must be operated slowly to prevent the gas source from flowing too fast. The dirt is blown into the solenoid valve. At the same time, the exhaust valve is opened for 30 seconds to ensure the air is clean.
3. After the normal operation of fully automatic blow molding machine, any part of the body do not reach into the machine to avoid injury to the robot. If the machine has abnormal noise, it can be observed after deceleration.
4. Check the emergency stop switch, safety door switch, protective device detection switch is normal.
5. Fully automatic blowing machine must be convinced when starting the mechanical part is good, no one inside the machine, no foreign body. Especially shake the position to avoid hurting people. At the same time, close the security door.
6. Check whether the triplet is abnormally leaky, whether it is blocked, and whether the water in the cup is too full.
7. Check whether the pneumatic components leak, the action is sensitive.
8. When fully automatic blow molding equipment is in operation, it must pay close attention to whether or not the machine has abnormal noise. To achieve early detection, timely stop and early resolution.
9. If the solenoid valve of the automatic blow molding machine is abnormal, it must be cleaned in a timely manner (3.5 million blows per bottle).
10. Blow mold must be cleaned and polished regularly.

11. Before production, check whether each moving part is firm and whether the screws loosen and fall off, especially if the impact force is strong, and whether the belt drive part is abnormal.
12. Check the warming head into the embryo, part of the work out of the embryo is normal. Insert the embryo if not in place to adjust the embossing device nut.
13. When starting the machine, the motor must be started and the heating machine must be delayed for 30 seconds to prevent voltage fluctuations. Before starting warming, make sure that the cooling water is not turned on.
14. After the warm-up starts (2-3 minutes), wait until the oven temperature rises evenly and press the embryo button. At the same time, the bottle blowing power must also be turned on, otherwise it will not blow the bottle.
15. Check if the lamp is damaged or broken. Replace it in time.
16. In the event of an emergency, the emergency stop button can be pressed for emergency braking. Then analyze the cause of the formation according to the site conditions and find a quick solution to the problem.
17. Check if the high-pressure gas source, low-pressure gas source, power source and water source are normal.
18. After each automatic blow molding machine is finished, it is necessary to clean the tools and screws and the like to avoid leaving them in the machine and affecting the normal operation of the machine.
19. Before every shift, you must add lubricant to each moving part. The swing arm can be added once (3 – 4) days. Heating machine large chain, small chain can be once a month. Check the main engine reducer and heating machine reducer for lack of oil. The main bearing can be added once every 3 months.
20. After the automatic blow molding machine is in normal production, the operator must observe the quality of the bottle from time to time in order to avoid voltage fluctuations or other factors affecting the blowing quality.
SuZhou Bestar Blow Molding Machine Technology Co.,Ltd. dedicated and specialized in manufacturing, R&D, and marketing of high-tech blow molding machines.